Cybernet IGX45-L19TS8 Guide de l'utilisateur télécharger pdf (Page 20)

Cybernet iONE-GX45 eWaste SOP USA

Page 14

Installing the CPU

NOTE: If you purchased your iONE-GX45 as a turn-key system, you must first follow

the instructions to remove the heat sink in order to be able to reach the CPU. Systems

purchased as ‘bare bones’ require the installation of the heat sink which is shipped in

the accessories box with the unit.

1. The socket has a plastic cap on it to protect

the pins from damage. This should remain

in place until actually installing a CPU.

2. Raise the plastic cap to reveal the socket

pins and open the cover by pushing down,

pulling out and up on the lever beside the

CPU socket.

Note: Do not touch the socket pins to avoid

damage.

3. Install the CPU after confirming the direction

for correct mating. Be sure to hold the CPU

by the edge of the CPU base.

Note: The CPU can only be installed in the

correct direction. Make sure the CPU pins are

completely embedded into the socket. If not,

take out the CPU with vertical motion and

reinstall.

4. Close the cover and the lever to complete

installation. Replace the heat sink.

NOTE: Any violation of the correct installation procedures may cause permanent

damage to your mainboard.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Pas de commentaire

Cybernet IGX45-L19TS8 Guide de l'utilisateur Page 20